| PARTS & MATERIALS | INSTRUCTIONS |
|---|
| (1 pkg) Radio Shack part #270-325 9v Battery Snap Connectors
(1 pkg) Radio Shack part #270-380 Mini Alligator clips
(3) 9v batteries
(2) 6" .999 pure (or better) fine silver wires
silver solder & soldering iron
| 
|
- Solder 3 snap connectors together in a series so that black wire goes to red wire
- Solder the red wire from one end of the series to an alligator clamp
- Solder the black wire from the other end of the series to an alligator clamp
- Cover the solder joints with shrink tubing or electrical tape.
- Curl one end of each of the fine silver wires so the alligator clamps will get a good surface to grip
- Snap a 9v battery into each of the snap connectors
- You're done!
|
Embellishments
- .9999 silver is better than .999 silver - costs more, too
- .999 is minimum purity you should use
- Clean your silver wires after each use. Just "polish" with a clean cloth.
|
To use:
- Clamp a silver wire to each of the alligator clamps
- Put the wires into a non-metal container of HOT water - wires should be 75% covered with 8 - 16 oz of water (less water = stronger colloid).
- DO NOT use metal implements!
- MAKE SURE the wires don't touch!
- MAKE SURE the alligator clamps aren't in the water!
- Watch your colloidal silver water creation process carefully! Finished product should be cloudy to pale yellow. Process should take just a few minutes (10 to 20 average).
- Either use your silver water right away or store it in a cool, DARK place.
|
Embellishments, part 2
- Yield: 3 minutes per 8 oz non-distilled water at room temp: ~3 ppm
- Pure well or spring water is preferred. Distilled water will take a lot longer. If your water source is not good (city tap water, for instance) and your colloid gets darker than pale yellow, there are too many impurities in your water - throw it out! (You shouldn't be drinking this water anyway!)
- Use hot water. If you can make your colloid while the water has just boiled, it's even better! The hotter the water, the stronger the colloid. For every 10 degrees that the water rises above room temperature (72 degrees), the ppm figure is approximately doubled. For instance, if 5 ppm resulted after 7 minutes of generating with 16 oz of water at 72 degrees, then 82 degrees would yeil 10 ppm. Note: Results will vary!
- Make sure your container is non-metal!
- If you choose to ingest your colloid, hold it under the tongue for a while before swallowing for maximum absorption. Note: Ingest colloidal silver with caution, and at your own risk!
|
NOTE:
- We recommend that you do research on using colloidal silver water before using it!
- Strand Enterprises and/or Lif Strand is NOT RESPONSIBLE for anyone else's use of colloidal silver water!
- We recommend that if you choose to ingest colloidal silver water, you also use lots of PROBIOTICS!
- ATTENTION: Strand Enterprises and/or Lif Strand is NOT RESPONSIBLE for anyone else's use of colloidal silver water!
|
